If you need more support for your legs on the front of the seat you can easely raise te driver's seat.
Remove the plastic nut (red arrow) of the lining of the frame. Slide then the plastic cover forward to remove it. |
![]() |
![]() |
The seat is fixed with two bolts on the left and right side to the frame. However ther are three bolts. By default, the support of the hinge mechanism is fixed (red circle) with two bolts. Remove all three nuts on the left side. |
Then remove the three nuts on the right side. If you put the seat in the highest position then you can reach the nuts a bit easier. |
![]() |
![]() |
Move the support on both sides of the seat one bolt to the rear and tighten the nuts again. Do this on both sides. |
Place the cover strip on the frame and fix it with the plastic nut. |