![]() |
Before you start you need to purchase some extra parts. In order to connect to the TEL 1 connector you need a Burry interface cable (left) and a Saab Kram cable (right) (the latter you can get at the dealer). | ![]() |
![]() |
Find the TEL1 connector. On the left picture you can see where you should find it. On the right picture you see where you can stick the base of the Bury (for example). |
![]() |
![]() |
Remove the rubber mat in the centre console , you can lead the cable trough existing holes (where the cable comes out) (left). You do not need to drill any holes. Connect the cable to the cramp Saab TEL 1 connector (right). |
![]() |
![]() |
Connect the Bury 9060 interface cable to the Saab cable connector (left photo). |
![]() |
![]() |
On the left image everything is neatly tyed up and all connectors connected. Matter of Plug and Play! |
![]() |
![]() |
Ready to use! When you use the phone you will see that at the SID. You can place and turn the Bury display in most directions, you will notice this when you get the grasp. |
![]() |